Everyone: Check Your Oil!
#1321
07-26-2009, 09:20 PM
Fyi
^Heard of G/Z revup people getting new trannies too occasionally in past. Mine was fine at swap time and still is with 40K miles on it. Some have that wine noise or it's found input shaft bearing going/gone or syncro(s) ng = warranty replacement as well.
Revup used for non revups, interesting for non revups owners. Wonder if they are still using the G non rev pt# 10102-AM8M1 and get a new ECU with that. Otherwise I could see a revup short block with non rev heads during assembly. Then stockpiled in distribution warehouse along with #10102-AC7M9 G revup long blocks. Z's have different pt#'s with their rev and non rev's.
Wish you the best with your fresh VQ and tranny.
Revup used for non revups, interesting for non revups owners. Wonder if they are still using the G non rev pt# 10102-AM8M1 and get a new ECU with that. Otherwise I could see a revup short block with non rev heads during assembly. Then stockpiled in distribution warehouse along with #10102-AC7M9 G revup long blocks. Z's have different pt#'s with their rev and non rev's.
Wish you the best with your fresh VQ and tranny.
Hey, I had Infinity put an ACT (SS)clutch/flywheel combo in during engine install. Now I am getting a raspy trans sound like a very bad TO Bearing. Listening with mechanical stethoscope on the trans it sounds like trans rear main bearing. Any ideas? Or have you heard of noise problems with ACT clutch/flywheel?
See YA,
Tim
#1322
07-26-2009, 09:39 PM
Join Date: Jul 2006
Location: PNW in Washington
Posts: 3,942
Likes: 0
Received 7 Likes
on
7 Posts
6MT Coupe
Again, thanks for the reply. FYI: part #10102-AC3M1 (ENGINE-BARE). Here is the trip: there is no transmission change notes on my Infinity invoice at all?
Hey, I had Infinity put an ACT (SS)clutch/flywheel combo in during engine install. Now I am getting a raspy trans sound like a very bad TO Bearing. Listening with mechanical stethoscope on the trans it sounds like trans rear main bearing. Any ideas? Or have you heard of noise problems with ACT clutch/flywheel?
See YA,
Tim
Hey, I had Infinity put an ACT (SS)clutch/flywheel combo in during engine install. Now I am getting a raspy trans sound like a very bad TO Bearing. Listening with mechanical stethoscope on the trans it sounds like trans rear main bearing. Any ideas? Or have you heard of noise problems with ACT clutch/flywheel?
See YA,
Tim
Heard many aftermarket clutch/fly with rattling sounds like idling in neutral, etc. Nature of those beasts without dual mass flys like OEM's. Nismo I read is real loud.
Not a clue really about tranny noises, being no personal experience. just what I've read. Think I've read a case or two with rear output shaft as well as what I've already mentioned prior.
G/L
#1323
07-26-2009, 10:17 PM
Let ya know!
Thanx for the updated pt #. No notes on tranny replaced, nice gift from dealer I guess lol.
Heard many aftermarket clutch/fly with rattling sounds like idling in neutral, etc. Nature of those beasts without dual mass flys like OEM's. Nismo I read is real loud.
Not a clue really about tranny noises, being no personal experience. just what I've read. Think I've read a case or two with rear output shaft as well as what I've already mentioned prior.
G/L
Heard many aftermarket clutch/fly with rattling sounds like idling in neutral, etc. Nature of those beasts without dual mass flys like OEM's. Nismo I read is real loud.
Not a clue really about tranny noises, being no personal experience. just what I've read. Think I've read a case or two with rear output shaft as well as what I've already mentioned prior.
G/L
I'll keep you in the loop.
Tim
#1324
07-29-2009, 11:34 PM
Join Date: Jul 2006
Location: PNW in Washington
Posts: 3,942
Likes: 0
Received 7 Likes
on
7 Posts
6MT Coupe
FYI Non Revup Owners:
Part number I had is still valid. Part number 'tim' gave is valid too. Here's why.
# 10102-AM8M1 = 03-04 6MT's only.
# 10102-AC3M1 = 04-07 5AT's only.
What about part number for 03 5AT's? Bare long block not offered from my source.
OEM part number look-up:
http://www.infinitipartsusa.com/part...gOEM&siteid=55
# 10102-AM8M1 = 03-04 6MT's only.
# 10102-AC3M1 = 04-07 5AT's only.
What about part number for 03 5AT's? Bare long block not offered from my source.
OEM part number look-up:
http://www.infinitipartsusa.com/part...gOEM&siteid=55
#1325
07-29-2009, 11:44 PM
#1326
07-30-2009, 10:19 PM
#1327
08-02-2009, 07:38 AM
#1328
08-02-2009, 10:47 AM
Check the muffler there may b alot of black soot, take it to mechanice get motor check thats about all u can do...good luk
#1330
08-02-2009, 11:03 AM
#1332
08-02-2009, 07:35 PM
#1334
08-03-2009, 09:35 PM
#1335
08-03-2009, 10:22 PM
go back and rip the service manager a new one for thinking you are stupid, then call infiniti customer care and report what they did.
There are some really shady infiniti dealers out there. Kind of surprising. Luxury division dealers acting like private used car dealers.
Last edited by PTownG; 08-03-2009 at 10:28 PM.