Random Little Question Thread
If I understand correctly, it's just a fault condition. That could me too much air, not enough, or that it's not getting signal from one or more sensors 
I'm not an expert on the subject though, as my car does not have TPMS (one of the very few IMO advantages of the 03.0)
I'm not an expert on the subject though, as my car does not have TPMS (one of the very few IMO advantages of the 03.0)
my ichiba camber arms and toe bolt kit didnt come with the template for the toe bolt...i had a friend make it for me using measurements i found online...does anyone have the real template to compare the lengths with the one i have now? here is mine for comparison thanks
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods
See post #11 in this thread for a PDF you can print out. http://my350z.com/forum/brakes-and-s...-template.html
Registered User
iTrader: (3)
Joined: May 2007
Posts: 4,383
Likes: 27
From: pinellas county FLA, queens N.Y.
so i found out i have a broken rear end link , ughhh
so i picked up a set of rear beffy ones from the stealership .. 36 bucks not bad ,,
going to install them tomorrow and rotate my tires ,..,
and im going to get my lower control arm inner bushings replaced on wednesday with
whitelines.. yayy
plan on getting alignment after that .
hope nothing else needs replacing ...
;(
so i picked up a set of rear beffy ones from the stealership .. 36 bucks not bad ,,
going to install them tomorrow and rotate my tires ,..,
and im going to get my lower control arm inner bushings replaced on wednesday with
whitelines.. yayy
plan on getting alignment after that .
hope nothing else needs replacing ...
;(
I have a lot of tread wear on the inside of my front tires. I was thinking that I needed a camber kit on the front but maybe I don't because of the inner wear? Also, I found a replacement drivers side fender. Does anyone have any experience with these. They all seem to be in the $150-$200 range. Thanks
