if i were you i wouldn't touch that **** if its welded....ask a reputable shop how much they will do it for, check out Wheelflip

 

Hmm.. Just called wheel flip and they said it'd be $186 per inner barrel. (19x6 step lip)

 

Inners will be around 150-225 each.

Let's say it'll cost 80-100 to split each rim. after all is said and done, it would have been cheaper to buy them direct from Work.

 

Have you checked VR wheels wheel inventory? Best way to do it IMO unless you can find some wheels for cheap in a rebuildable state(beat up with weak specs)

 

http://shop.wheelflip.com/collection...9-inner-barrel

 

i like vr, but here's your typical call to vr


buk lau bic boiiiiiioiiii

 

Lmao!

 

yeah that sounds about right

you really should have just bought wheels with better specs

 

Beaguilar: you already bought wheels? I thought you were still doing research

 

i'll sell you my SSRs for 2600+shipping.

 

Ill trade my 6" step lip for your 6.5" to make it easier to fit

 

Nope. My next setup will probably be 19x12 max. It's gonna be very conservative.

 

Well, I'm putting it out there for you or any potential buyer. At the time, they only had 6" outers in stock

 

Yes I'm still looking! Haven't bought anything yet.

 

In need of some help please: my fronts are 19x9 +16 and rears are 19x11 -19. I'm planning on getting the rears re-barreled to be a little less aggressive. The two choices I have are 10in -6 and 10.5in -12. Any advice on which i should go with? I had my fenders rolled and a slight pulled when i was working with the 11 -19. I would like to sit flush with the fender or very close to it. Thanks for the help in advance.