- Rough Cold Start - Idles & Runs Fine (Even cold)
- P0340 Bank-1
- Connecting Rod Bolt Head. What is it?
- Oil Change Interval
- Suspect a bad throw out bearing...HELP NEEDED!!
- Random Misfire mainly at idle, code P0301 Cylinder 1 misfire
- 06 Coupe A/T Needs New Wire Harness?
- Help
- Idling Issues Post Winter (COVID Sporadic Problems)
- 2005 G35 Coupe - Ticking noise that matches engine RPM
- Engine rattle or ticking noise?
- Will a 03 wiring harness MT work on 04 ECU
- Junk or Keep Need expert advise! Pictures!
- Best non longtube Headers to go with?
- Header bolt thread pitch size?
- Here is why you cannot replace the driveshaft u-joints
- Engine has intermittent hiccups during idle after warmup
- Could I swap an 06 G35x motor into an 04 coupe?
- Bad thermostat?
- All 4 O2 Sensor Circuits High Voltage, Random Miss, Bank 2 Too Rich
- Car lacks performance, regains it after ECU reset (and loses it shortly after)?
- Check Engine light for Bad Camshaft Position Sensor, then went away
- Which radiator for 05 G35 5AT Coupe? Oil cooler?
- Coolant open to atmosphere?
- AC Pulley Misalignment Squeak?
- Engine cuts out
- No spark, no check engine light, what to do?
- With replacing valve cover gaskets is replacing the valve covers required?
- VQ35DE-T needs rebuild
- Help! Car dies randomly, complete loss of electricity
- SMH not sure what to do next with P0300
- Engine
- How bad is this?
- P1759 & P 1757 (Car in limp mode)
- Flywheel bolt snapped wtf do i do
- Help with manual bell housing and engine connection
- Is there a trick for?
- Intermittent no start condition, now complete no start.
- P0300 Code SES Light Gone?
- Help! 05 G35 Sedan 6MT C1131 P1122
- Overheat help please
- Engine stand suggestion
- Did i buy the wrong engine?
- Advanced Camshaft Timing After Clutch Job (2005 Infiniti G35 6mt)
- timing components help
- Gear oil burning smell
- U1001 and P0300 HELPPPPPPP!!!!!
- Starting Issue
- Piston Rings
- No start after timing chain install
- No crank, no start 2005 G35 coupe
- Sending unit(s) failure?
- Need Help ASAP.....
- OBD2 Mode 6.
- P0300 code and cat getting red hot
- 2003 VQ35DE Rebuild Suggestions
- G35 gets rod knock - what next?
- p2128 p2123 Codes help!
- 2007 G35 Won't Start After Sitting for 1 Year
- Bleeding the G35 cooling system
- Help please
- Engine suggestions/dealers
- 2003 G35 twin turbo fuel pump issues.
- Need a rev up rebuild or swap in NJ , will pay $$$$
- Valve cover Gaskets Round 2 Questions
- Why *not* to use cheap cam sensors...
- Car stalls under heavy breakin
- Please help! Code P2122 and P2127
- Please help, Car sputtering after tune
- Engine swap
- Mystery Oil Leak??
- Cam Position Sensors - Same on Both Sides?
- Cold Start Rattle 1-2s long
- Oil pressure light
- Aftermarket vs. OEM Fan Clutch 03.0 G35 Sedan
- P1283 and valve cover
- G35 auto trans replacement
- Blank gear selector, not shifting or starting.
- Transmission type?
- Valve cover gasket replacement
- Help identifying gaskets.
- Auto trans
- Engine Swap
- Need Some Help...
- running rich
- Engine, Transmission, and other parts weights
- Cool problems
- Smoke in harness
- Engine swap
- G35 sedan throwing codes p0011,p0442 and p0300
- Post Engine Swap Slow Throttle Response
- JDM vs US 2006 RWD transmission vq35
- Rev Hang New to Infiniti
- Weird metal rattling (deep loud) noise at low rpm
- VQ35HR N/A Build
- My build plans!
- Looking for some help for a friend
- Who makes this plenum
- Misfire codes
- What are these two tube/wires for? The previous owner just cut them.